ATOMIUM Mototec 4 (100 ml) - Four-stroke engine additive

• Increased power – optimized clearances in the cylinder-piston assembly and valve train prevent fuel and combustion products from entering the oil, increase compression and improve fuel combustion, resulting in more power.
• Fuel savings – reduced friction losses and prevention of fuel entering the oil reduce fuel consumption by 4–6%.
• Oil savings – optimized clearances significantly reduce the amount of oil entering the combustion chamber, helping prevent oil consumption through burning.
• Reduced vibration and noise – cleaning restores the normal mass of parts, while optimized clearances and a thicker oil film reduce unwanted engine vibration and noise.  
• Reduced smoke – optimized clearances in the cylinder-piston assembly reduce the amount of oil entering the combustion chamber and improve fuel combustion.
• Reduced gearbox noise and improved coasting – optimized clearances between gear teeth and the restoration and protection of bearings reduce gearbox noise and vibration, while reduced friction improves coasting.

Preventive benefits

The protective layer reduces wear on friction surfaces and significantly extends the service life of the affected parts.

"MOTOTEC 4" works in two ways: it cleans friction surfaces and activates the process by which metal microparticles in the engine oil bond to them. These particles form a protective layer that:

• is stronger than the metal surface of the part itself;
• retains a thicker oil film;

The protective layer continues to form until temperature, pressure, vibration and other parameters reach optimal levels, at which point the process stops automatically.

The compound acts throughout the engine:

• in the valve train – in hydraulic lifters, valve guides and other friction points;
• in the cylinder-piston assembly;
• in the crank mechanism – particularly in the crankshaft bearings;

If the gearbox shares an oil sump with the engine, the compound will also treat its parts: the surfaces of gears and bearings. The compound does not affect the clutch friction plates or change their characteristics because they are made of composite materials.

Notes

• Shelf life: 5 years. The manufacturing date is shown on the label.
• Not recommended if parts or assemblies are mechanically damaged.
• The sediment at the bottom of the bottle consists of mineral microparticles, the main active component of «MOTOTEC 4». It is therefore essential to shake the bottle thoroughly before adding the compound to the engine. (Depending on the production batch, the sediment may range in color from light green to dark gray or black.)
• «MOTOTEC 4» does not interfere with clutch operation or interact with the clutch friction plates.
• To maintain protection against engine wear, adding the compound after every oil change is recommended.
• «MOTOTEC 4» is compatible with all types of fuel and oil.
• Adding 2–2.5 times the recommended amount is not harmful to the engine and does not interfere with its operation.
• «MOTOTEC 4» does not affect the characteristics or condition of parts made from composite materials or rubber components.

Instructions for using «MOTOTEC 4»

• Warm the engine to operating temperature.

• Turn off the engine.

• Shake the bottle thoroughly so that the sediment at the bottom is distributed throughout the liquid.

• Pour the compound into the engine oil filler opening:

If engine displacement is less than 500 cm3, use half a bottle.
If engine displacement is more than 500 cm3, use a full bottle.

• Start the engine immediately after adding the compound.

• Ride for 15–20 minutes under normal operating conditions.

Complete engine treatment follows this schedule: